Replacing Xerox compatible drum unitThe kit consists of these items:
- Imaging unit
- Filter
- Blower/brush cleaning tool
Remove the used imaging unit
- Turn power off when you replace any of the components.
- Open the front door.
- To unlock the imaging unit, turn the large blue knob counterclockwise.
- pull out the imaging unit until it stops.
- Lift up the blue handle to the left of the imaging unit to release the catch.
- Slide the imaging unit out all the way; cover it completely to prevent damage from exposure to light, and set it aside.
Clean the sensors
- Using the blower/brush cleaning tool that was included in the imaging unit packaging, clean the three sensors inside the printer.
Replace the filter
- Pull out the used filter and dispose of it as normal office waste.
- Insert the new filter.
Insert the new imaging unit
- Unpack the new imaging unit
- Turn the two small blue knobs clockwise to align the triangles.
- Remove the tape from the protective plastic sheet; then remove the sheet from the imaging unit.
- Insert the new imaging unit into the printer, holding it by the blue handles.
- Release the left handle and slide the unit in until it stops.
- Turn the large blue knob clockwise to insert the imaging unit completely and to lock it.
- When properly installed, the lock icon aligns with the triangle, close the front door.
Reset the copy count
- Press the Yes button, then the Confirm button to automatically reset the copy count.